Club Locarno Craft Signout
  1. Kayaking
  2. Select Skipper
  3. Select Craft
  4. Select Crew
  5. Review

Maintenance Log

CraftDateStatusDescriptionRepairs NeededResolution NotesResolved OnAction
10 - Avocet2025-04-20 09:45AvailableChip on bow gel coat. --- Update
10 - Avocet2026-04-11 13:08AvailableSeat straps are not attached to the back of the cockpit, no clips either--- Update
12 - Ask2026-04-11 12:20Available - please review notesminor chip on the bottom bow. gel coat could be good; and same thing at the skeg --- Update
12 - Ask2026-04-11 12:28Available - please review notesseat fabric could do with a repair --- Update
12 - Ask2026-05-24 19:34Available - please review notesI see small chips along bottom of boat next to the skeg box. Maybe these are not significant?--- Update
13 - Embla2024-07-18 08:30AvailableBack band ripped. Still useable--- Update
13 - Embla2024-09-29 16:35AvailableChip in skeg area--- Update
13 - Embla2025-06-22 13:42Available - please review notesA piece of foam can unglued from under the front left side of the seat. the kayak can be paddled, but the seat will rub and grind against the fiberglass until the foam is replaced, so might be better to not use until repaired. the curved foam piece is in the desk in the kayak shack--- Update
13 - Embla2026-04-11 12:14Available - please review notesmesh missing--- Update
13 - Embla2026-07-14 17:36UNavailableDid not use, taking it out of commissionNew chip in skeg box noted--extends past gel coat into fiberglass-- Update
14 - Passat Double2026-04-11 12:46Available - please review notesvery small chip - hatch at the stern, left side, can see daylight from inside the hatch; scratches middle hatch right side; left knee pad cockpit at the stern needs patching/replacing; left knee pad bow - needs glue. --- Update
14 - Passat Double2026-04-11 12:56Available - Please review notesbow, bottom some chips need gel coatRequires plastic keel guard-- Update
16 - Luna2026-04-11 13:01Available - please review notesA crack on the outside bottom hull near the middle. Can be used with caution and requires a patch on a dry day --- Update
17 - Tyee2026-04-11 12:41Available - please review notesknee pads need to be re-glued--- Update
17 - Tyee2026-07-01 15:05AvailableMultiple deep scratches, couple of spots are through the gel coat. Multiple spider cracks at the hull closer to the center line. Thin parallel crack on the hull just on the opposite side of the end of the cockpit.--- Update
2 - Cetus HV2026-07-01 14:36AvailableSmall leakage in the stern (big rear hatch). Leakage is probably from the hull (the upper part of dry bag was dry, while the bottom was wet and hatch contained small amount of water)--- Update
3 - Quantum2025-11-08 16:32Availablegel coat chip at bow tip--- Update
3 - Quantum2025-11-14 09:54Availableseat back adjuster cable broken--- Update
3 - Quantum2025-11-14 09:55Availableseat cracked. needs a little fiberglass--- Update
3 - Quantum2026-04-11 11:18Available - please review notesKnee pads need replacing. Broken cable behind seat.--- Update
4 - Cetus MV2025-04-20 09:40AvailableChip on back of coaming--- Update
4 - Cetus MV2025-10-13 10:56AvailableLong cracks in gel coat on hull below near thigh braces(I guess, either put loaded on uneven surface or transportation, straps to thight)--- Update
4 - Cetus MV2026-04-17 19:22Availablespider crack 1/3 back from bow starbord side. --- Update
5 - Spartan2025-11-08 16:37AvailableGelcoat chip on bow and aroundskeg box. Gelcoat spider cracks across hull - around foot braces--- Update
5 - Spartan2026-04-11 11:12Available - please review notesKnee pads have to be glued in. Needs to dry out first--- Update
5 - Spartan2026-07-05 11:18Available - please review notessmall dent in bottom of bow, some water leaking from cockpit to back hatch--- Update
55 - Tyee XLC2023-10-07 18:00AvailableFront bulkhead leaks. The bulkheads are just plastic and are sealed with silicon(i.e. they are not structural like other boats.) So a little more silicon sealant should fix it. Leak seems to be left side where you can see light. --- Update
55 - Tyee XLC2025-04-20 09:44AvailableChips in bow gelcoat. Needs new #55 --- Update
55 - Tyee XLC2026-05-12 21:00Available - please review notesSome water in front hatch after self-rescue.--- Update
6 - Chilco2019-08-20 12:44Available - please review notesnylon keel strip broken - needs replacement--- Update
6 - Chilco2023-07-15 10:01Available - Please review notesGel coat chip gel coat repair needed-- Update
64 - Titan VI2025-11-08 16:28Available - Please review notesNeeds new rudder deployment cord (5mm) and Bungee (5mm)--- Update
65 - Spartan VI2025-11-08 16:34Available - Please review notesgel coat chips. Bow centerline, around skeg box and along centerline. Also many spidercracks--- Update
7 - Karla2025-11-08 16:30AvailableLarge gel coat chip on bow along centerline--- Update
7 - Karla2025-12-02 14:33Available - please review notesHatches are leaking when rolling. Two rear ones more than the front. Possibly hatch covers, one has visible damage. Requires pressure testing to verify rims are intact.--- Update
70 - Atlantis Talon Double2025-04-14 08:34Availableneeds new seat backs--- Update
70 - Atlantis Talon Double2025-11-13 21:13AvailableGelcoat chips: - Small Gel coat chip bottom of the stern - Larger gel coat wear on the bow - Bow Cockpit gelcoat chipped - Gelcoat damage stern cockpit partially repaired--- Update
70 - Atlantis Talon Double2025-11-13 21:13AvailableDeck line need replacement behind stern seat needs replacement--- Update
70 - Atlantis Talon Double2026-05-11 09:40AvailableNumerous gelcoat patches needed Seat backs need repair Deckline behind stern cockpit needs replacing *Carry handles showing wear on rope*--- Update
8 - Idun2024-07-31 16:00Available - please review notesplastic cleat(not sure if that's what it's called) on bow port side decking line broken. Bungee still holding, but deck line loose at that one point. --- Update
8 - Idun2026-04-11 12:02Availablespider cracks on bottom of hull under cockpit area--- Update
9 - Bylgja2024-09-18 17:30Available - Please review notesBig gash, Some resin and gelcoat. Puncture has not pierce through - so it is taped with helicopter tape and should be OK-- Update
9 - Bylgja2025-08-18 15:10AvailableNeeds new rope on the bow handle. Rope is worn. --- Update
9 - Bylgja2025-09-07 16:45AvailableNo front carry toggle. It was badly frayed so I cut it off so it doesn't break and cause the kayak to drop while being carried. The toggle is in desk--- Update
9 - Bylgja2026-06-25 00:13Available - Please review notesSmall holes on a keel line of the hull (in the place of previous repair) and cracks on the sides of the front part (where the feet are). Cracks letting in water. Gel coat chipped on the bottom tip of the stern. Marking as unavailable as water is getting in between gel coat and fiberglass.added some helicopter tape but still needs repairs-- Update
Epic V102024-10-07 17:35Availablefiberglass or gelcoat patching needed at the stern handle--- Update
Epic V8 (S1)2024-10-07 17:38Available - Please review notesCrack on port side Port side seam appears to be leakingTaped the crack, but needs fiberglass repair-- Update
Epic V8 (S1)2025-10-22 18:41UNavailablescrews for foot paddle on right side are missing. detached.new screws-- Update
Epic V8 Pro (S3)2024-06-20 14:36Available - please review notesThe small rubber "covers" for the bottom of the foot-plate come off easily. I have pinned them to the blue board in the Rowing Shed, with pin tape. I found them taped to the bungees of the V8 Sport, with a note saying they should be put on the fot-plate bottom (presumably to protect the area just under the plate), but, as I say, they just come off. If they must be used, they should be siliconed or glued on. Otherwise, they can be lost very easily.--- Update
Epic V8 Pro (S3)2026-07-04 21:30Available - please review notessounds like very small amount of water in hull. did not have time to check it out tonight. --- Update
OC1 Hurricane2025-11-08 16:29Availablepaint/gel coat and seam tape need inspection and refurburshing--- Update
Think Ace (S2)2026-07-11 17:05UNavailableSelf bailer falls open. Comparing to one on another boat, there are two prongs missing which tension the moving part of the bailer. Have taped the bailer closed so it isn't damaged on the stand and put pink tape on the boat--- Update
Think Zen (S4)2024-10-07 17:47AvailableSmall Hull chip on the bottom towards the bow. May have punctured right through. Mark Stoakes has taped it with helicopter tape until wee have a fiberglass clinic.--- Update
Think Zen (S4)2025-09-07 16:31Availablebroken grommet (holding the bungee cord), gelcoat worn through at heels, a few gel coats chips in seat area and bow--- Update
Think Zen (S4)2026-06-13 13:08Available - please review notesFoot plate probably need rubber foot like the V8 Pro. The rudder also appears to have been slightly damaged.--- Update
Think Zen (S4)2026-06-13 13:13Available - please review notesThe gel coat back of the seat is starting to chip.--- Update